QUALITY ELECTRODE HOLDERS
"AF"/"HT" Series

LENCO electrode holders are designed to fit comfortably in the welder's hand. Each design allows the LENCO electrode holder to fit a welder's hand like a glove and provide superior electrode control.

Choosing The Right Size...

ELECTRODE HOLDER
The choice of an electrode holder that will be lightweight, run cool, and at the least cost can be determined first by the maximum rod used and second, by the maximum amperage setting used. LENCO holder numbers indicate the amperage capacity. For example, an AF-2 holder has a maximum amperage capacity of 250 amps. Match the holder to the rod and amperage used for greatest efficiency.

LENCO “AF”/“HT” Series Electrode Holders Offer All These Features
1. LENCO's durable tip insulators are molded from a high impact/high temperature fiberglass compound.
2. The upper lever is fully insulated. The low profile "AF" Series design fits your hand comfortably while the "HT" Series allows greater hand clearance.
3. LENCO's powerful spring holds the electrode securely in place and prevents electrode slippage. The spring is protected by a Lexan cup insulator.
4. LENCO's specially designed oval-point screw makes it easy to install our holder on a cable. Just strip off the appropriate length of cable insulation and insert it into the holder body, then tighten down the large oval-point screw with an allen wrench. This makes an excellent connection. As a safety precaution, the handle retention screw is upset to prevent removal.

Material Construction
AF/HT-1, 2, 25, 3, 35 and 50 holder
handles are molded from a durable
glass filled nylon material with good
heat and impact resistance.

LENCO electrode holders (upper and lower tongs) are made from a high copper alloy for maximum conductivity and strength. The top and bottom tip insulators are a molded fiberglass compound and will withstand intensive heat and impact. Parts for all models are replaceable. The oval-point screw cable connection is standard on all models.

QUALITY ELECTRODE HOLDERS
Light, Medium, and Heavy Duty Models

Holder Replacement Parts
Replacement parts for all
LENCO electrode holders are available and easily installed. Select the parts you need from the illustration. Part names are shown below and the part number is under the holder number in the same column.

ELECTRODE HOLDER
1. Tip Insulator w/Screws
2. Upper Body Tong, Insulated
3. Spring Cup Insulator
4. Spring Set (with items 3 & 5)
5. Spring Flat Insulator
6. Molded Handle
7. Hinge Pin
8. Lower Body Tong
9. Oval-Point Screw